| Cautions |
| Every time you change the Mode, the SW-2000 will go back to the warm-up state. Therefore, make sure to turn the Dial toward the left to "OFF" before you adjust the intensity level. |
| During the session, do not remove your feet from the Foot Pads or peel off the Electro-Pad. |
 |
| 4. Finishing the session: Once the timer is off, you will hear 3 beeping sounds, signifying the session has ended. (All the lights on the Display Board will go off at this time.) |
| When the session for the feet is finished: |
When the session for the shoulders or waist is finished: |
| Turn the Timer back to "OFF." |
Turn the Timer back to "OFF." |
Remove the belts from your legs.
Remove your feet from the Pedals. |
Peel the Electro-Pad off your skin.
Replace the adhesive plaster over the Pad.
Unplug the Electrode Plug from the Main Unit of the SW-2000. |
|
|
| 5. Turn off the Main Switch of the Main Unit. (All of the lights on the Display Board will go off at this time.) |
| 6. Unplug the A.C. Adapter from the power bar. |
| 7. Unplug the other end of the A.C. Adapter from the Main Unit of the SW-2000. |
|
Download this document
Note: This is in PDF format. You can view this document using Adobe Acrobat Reader.
 |